Save settings and connect the device to the new network.Either copy or modify your router’s credentials for the repeater.Find and connect to your router’s Wi-Fi network.Set up a new SSID/username/password if desired.Open a web browser and type in the access URL.Find the extender’s SSID (network name) on your device and connect.Note down login details on your extender and plug it in.It’s no big deal if you can’t use WPS, since there’s always at least one other method of connecting an extender to a router, and that’s by connecting to, and logging into, the extender itself and configuring from there. What can you do in these cases if using the WPS connect feature just isn’t possible for whatever reason? Also, it may be disabled or you may just not have access to the router to use it. It’s true that the WPS button isn’t available on all routers, especially older ones. What Is WPS Setup Doesn’t Work Or Isn’t Available? The extender SSID might just have an “_EXTENDER” or similar suffix at the end, but has the same name as your router on the Wi-Fi networks list (if you’d rather not have this happen and have totally separate credentials, it’s better to set it up via a laptop/browser connection).
Also, with WPS configuration, your extender will usually copy your router’s SSID (network name) and password, so you’ll use the exact same credentials to connect to it as you do your router.
#WPS BUTTON ON NETGEAR ROUTER FREE#
Step #4 – You are now free to connect to your extender’s network, which is in turn connected to the router’s network and “capturing” it’s signal. On some extender models, the WPS light might go off once fully connected, after a few minutes.
A solid green WPS light on both the router and the extender means they are both connected. The LED might start flashing slower and slower, but eventually, should turn solid. While scanning and/or connecting, you’ll see both WPS lights blinking/flashing. Step #3 – You need to wait for up to 2 minutes for the router and extender to find each other via their WPS scans. Now you’ve got both your router and extender’s WPS feature scanning for nearby devices also doing the same. However it’s labelled, push and hold it until it too starts blinking. Step #2 – Then, find and push the WPS/Pair/Connect/Wi-Fi button on your extender:Īgain, it can be labelled differently on different models, but there’s usually only one button your can push anyway – it might have WPS/Pair/Connect written on it, or just have a Wi-Fi symbol of some kind on it. However it’s labelled, push or push and hold it until it the button/LED starts blinking (means it’s searching for other WPS enabled devices). It might be a button labelled as WPS/Pair, or might just have the standard two arrows symbol as in the featured image above. Step #1 – Firstly, with your extender plugged in, find and push the WPS Button on your router: Connecting A Router And Extender via WPS (Illustrated Steps) Now let’s cover the steps in more detail with screenshots. You can now connect to the extender as an extra access point.A solid green light indicates they are connected.Your extender will clone your router’s SSID/password.
#WPS BUTTON ON NETGEAR ROUTER MANUAL#
It’s also a good alternative method if the manual custom configuration method doesn’t work for whatever reason. Therefore, if you have physical access to your router and it has a WPS button, this can be the way to go if you just want to quickly connect your router and extender in a no nonsense way, and get connected without any complex custom configuration. This really is the easiest way to connect a new Wi-Fi extender you have to your router, and can sometimes be done in seconds versus the more long winded method of logging into the extender which can take several minutes and need several goes to get it right first time.
0 kommentar(er)
